"Nozzle offset test failed" with every print. (UM3)

[Flutelab 4]

Hi UM folks,

I get a "Nozzle offset test failed"message with every, really every print I do. And nearly all of my prints are using only one extruder. I uncheck the other extruder in Cura when slicing, so what the other extruder does is totally irrelevant. I installed the latest firmware on my UM3, and it still happens. Does anybody have an idea why this is happening? thanks.

[Enigma_M4 123]

Hi,

does the lift switch work properly (is the right nozzle going up and down when the printer switches)? If not, you have to (re)calibrate the lift switch.

Regards

[Flutelab 4]

It works ok, but I did a calibrate, again. It does seem to help.  Thanks!