Print volume height

[koles 0]

Good afternoon. When an object is reproduced, the height of the printed volume decreases, and because of this it is impossible to cut into layers. Please tell me what am I doing wrong and how to fix it? Thank you very much in advance.

[Slashee_the_Cow 276]

Looks like you're printing in One at a Time mode, which limits your height to that of the printer's gantry so that it doesn't knock over stuff it's done before.

 

Go to Special Modes > Print Sequence and change it to All at Once. Just be aware that this will make it travel between each object every layer as it prints, which might cause some stringing.