- Solution
29 minutes ago, Slashee_the_Cow said:If you could upload the Cura project file (.3mf, in Cura get it ready to print then go to File > Save Project) it would really help. I can't even see what's wrong based on that screenshot because I don't know what you're trying to do.
Thanks for spending time on this. I figured it out, the box was sligthly tilted and not flat to the surface as it should have been. Its OK now.
- 1
Recommended Posts
Slashee_the_Cow 267
If you could upload the Cura project file (.3mf, in Cura get it ready to print then go to File > Save Project) it would really help. I can't even see what's wrong based on that screenshot because I don't know what you're trying to do.
Link to post
Share on other sites