UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
We'll be able to help you can provide a lot more information than that. What would be best is if you can share your Cura project file (.3mf, in Cura, go to File > Save Project) but as well help to know things like: is there a specific error you're receiving, can you slice the same model in a different kind of filament, can you slice other models in carbon nylon?
I'm not an expert with UltiMaker printers so I'm afraid I can't offer too much specific advice myself, other than making sure you have the correct print core selected.
You might also find help in the extensive knowledge base or by contacting UltiMaker support on their support site.
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Slashee_the_Cow 541
We'll be able to help you can provide a lot more information than that. What would be best is if you can share your Cura project file (.3mf, in Cura, go to File > Save Project) but as well help to know things like: is there a specific error you're receiving, can you slice the same model in a different kind of filament, can you slice other models in carbon nylon?
I'm not an expert with UltiMaker printers so I'm afraid I can't offer too much specific advice myself, other than making sure you have the correct print core selected.
You might also find help in the extensive knowledge base or by contacting UltiMaker support on their support site.
Link to post
Share on other sites