UM2+ Connect - Any way to change material temperature during printing?

[Andrew_F 0]

Hi all,

As per the subject line.
 

The interface on a UM2+ connect is rather spartan.

Is there any way to change print temperature after a print starts - as you know, you can see that material flow is poor and needs an added 5°C print temperature, but the only way I've been able to do this is to abort the print, change material temp in Cura, reslice and restart.

Sure that there must be a more practical option... ...

 

Any advice or assistance you can provide is greatly appreciated.

 

A

Edited May 19 by Andrew_F

[Dustin 150]

Unfortunately the interface of the 2+Connect does not support this.

[Andrew_F 0]

THanks for this Dustin, and apologies for the late reply.