UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· Creality K1 Max printer not in Printer List
Probably. Most Creality printers (except the really really new ones) are pretty similar so the profiles usually aren't too different. I don't know enough about either of those (I mainly know the Ender-3 Vx models) to know if there's any major differences. Just watch your first few prints and if it looks like it's going to hurt itself, cancel the print.
Official disclaimer (sorry, comes with the job of assistant mod):
UltiMaker is not responsible for adding definitions for third party printers to Cura. They must be contributed by either the manufacturer or the community.
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
Slashee_the_Cow 543
Probably. Most Creality printers (except the really really new ones) are pretty similar so the profiles usually aren't too different. I don't know enough about either of those (I mainly know the Ender-3 Vx models) to know if there's any major differences. Just watch your first few prints and if it looks like it's going to hurt itself, cancel the print.
Official disclaimer (sorry, comes with the job of assistant mod):
UltiMaker is not responsible for adding definitions for third party printers to Cura. They must be contributed by either the manufacturer or the community.
Link to post
Share on other sites