Thank you for replying
I compared it between the two versions and found additional settings in the walls, where it was 39 mm, so I changed it.
Now everything is OK
Some parts of model disappear after slicing on cura v5.7.0 and the latest
By
Marwan
in UltiMaker Cura
Go to solution
Solved by ahoeben,
-
Our picks
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
UltiMaker Cura 5.9 stable released!
ArunC posted a topic in UltiMaker Cura,
Here comes Cura 5.9 and in this stable release we have lots of material and printer profiles for UltiMaker printers, including the newly released Sketch Sprint. Additionally, scarf seams have been introduced alongside even more print settings and improvements. Check out the rest of this article to find out the details on all of that and more-
-
- 5 replies
Picked By
MariMakes, -
-
Introducing the UltiMaker Factor 4
ArunC posted a topic in UltiMaker 3D printers,
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications-
-
- 4 replies
Picked By
MariMakes, -
-
.png.790188cb2d32e3558395d7e5fbc992f3.png)
Recommended Posts
ahoeben 2,012
Here's a good article: https://github.com/Ghostkeeper/SettingsGuide/blob/master/resources/articles/troubleshooting/missing_parts.md
Either the missing parts are too thin (and you had settings enabled in 4.13 to compensate for that, most notably 'Print thin lines'), or the model is "non-manifold", and you had settings enabled in 4.13 to compensate for that.
Link to post
Share on other sites