UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Some parts of model disappear after slicing on cura v5.7.0 and the latest
Either the missing parts are too thin (and you had settings enabled in 4.13 to compensate for that, most notably 'Print thin lines'), or the model is "non-manifold", and you had settings enabled in 4.13 to compensate for that.
Posted
· Some parts of model disappear after slicing on cura v5.7.0 and the latest
Thank you for replying
I compared it between the two versions and found additional settings in the walls, where it was 39 mm, so I changed it.
Now everything is OK
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
ahoeben 1,981
Here's a good article: https://github.com/Ghostkeeper/SettingsGuide/blob/master/resources/articles/troubleshooting/missing_parts.md
Either the missing parts are too thin (and you had settings enabled in 4.13 to compensate for that, most notably 'Print thin lines'), or the model is "non-manifold", and you had settings enabled in 4.13 to compensate for that.
Link to post
Share on other sites