UlrichC-DE 114
How are you trying to install the firmware?
It doesn't seem to work at a higher level than the operating system.
For example, if the WiFi or network component fails due to heat generation, I would try USB.
How are you trying to install the firmware?
It doesn't seem to work at a higher level than the operating system.
For example, if the WiFi or network component fails due to heat generation, I would try USB.
https://support.makerbot.com/s/article/1877434822572
Using the link above to do a firmware recovery. Followed instructions using a micro SD card. Unit looks to be booting and stalls when the displays comes back on with installing new firmware. It does look like the software stalls when looking for the firmware. Unsure if the S7 requires a different set off instructions to make this work or the recovery files are not for the S7?
Recommended Posts
fbrc8-erin 299
You could try doing the recovery image again on a different microSD card or reformatting and trying on that one again, but your best move at this point is probably to put in an official support ticket: https://support.ultimaker.com/s/
Link to post
Share on other sites
PGilladditive 0
Thank you for the reply,
Have tried another micro SD card (Kingston) with the same result. Also, have contact UltiMaker support who sent over another recovery image to try. This also had the same result. Looks to be stuck at the point of loading the new firmware. I will see if I have another micro SD card and try again. If all fails look like the mainboard is the issue as informed by UltiMaker.🤥
Link to post
Share on other sites