This is on an Ultimaker Original?
Yes it is. Sorry for not stating that.
This is on an Ultimaker Original?
Yes it is. Sorry for not stating that.
You can try printing new slider blocks. But you'll need to get the printer working first
Kapton tape is a lot thinner than Blue tape. You can use that to make the bearing slightly thicker, should work much better than with blue tape.
Make sure you put the tape on evenly. Cover the whole surface of the bearing (bushing, to be exact) with Kapton tape, not just parts of it.
Bit of super-glue to secure the bearing till you printed a replacement might do the trick.
How old is this Ultimaker? I've never seen the happening before, and I've seen just about every problem you can imagine.
The printer is a couple years old self sourced in a group with some slight mods I think just thicker z rods.
Is there a recommended replacement xy block?
I was looking at this one:
https://www.youmagine.com/designs/reptar-xy-version-two
Recommended Posts
illuminarti 18
This is on an Ultimaker Original?
Link to post
Share on other sites