The only thing you should have to do is tell Cura that your new nozzle size and set the shell thickness to a multiple of your nozzle size.
Perhaps the new nozzle has a bad shape? Perhaps the tip isn't flat?
(I change nozzle sizes often)
Then i dont understanding this print :/
It looks like over extruding and then under extruding.
Recommended Posts
gr5 2,224
The only thing you should have to do is tell Cura that your new nozzle size and set the shell thickness to a multiple of your nozzle size.
Perhaps the new nozzle has a bad shape? Perhaps the tip isn't flat?
(I change nozzle sizes often)
Link to post
Share on other sites