Ah.. yes.. Thats another parameter I set... I set the filament diameter to the manufacture spec (my caliper had a dead battery last night -- so did not do a direct measurement...) I'll check that out...
Initial layer thickness is set to .3 (the default) which worked for good brim on previous prints.
edit.
filament diameter checks out to be within spec and set right...
Recommended Posts
solid-print-3d 30
Looks like it's just printing a super thick first layer... What is your initial layer height set to? Try leveling the bed with a little more tension on the paper, or print something very large with 30 lines of brim or so, and as it goes around, printing that large brim, calibrate the bed on the fly until you get nice tight lines...make sure your Cura setting for initial layer height is set to .2mm or so.
Don't forget to measure the filament, in case you haven't, and enter those values in the material menu of the printer.
I'm sure one of the "big dawgs" will chime in with some more useful info, but that's it for now.
Link to post
Share on other sites