"hidden" Z-line

[ignace-de-keyser 1]

Hello

I saw in the latest patch notes that the Z-line is hidden internally. Is there a possibility to turn this feature off? I often print shapes completely hollow like zarfs. However with this hide zline feature, the inside of the print is imperfect. Is there a way to turn this feature off?

And is this a spelling mistake or a am I misunderstanding it.

 

[Daid 306]

You are mistaken on this feature. It tries to hide the Z line in "inside" corners.

Simple example, on the following object, the Z scar was on the red line:

With the new code, it's on the green line, where it's as good as invisible.

 

[DidierKlein 729]

Great Stuff Daid :mrgreen: i looked at one model that had an ugly Z-scar in the front now it looks much better (in a gcode viewer) is there any way to see the z-scar in Cura?

 

[Daid 306]

Z scar is usually where you see small blue up lines.

 

[ignace-de-keyser 1]

Ok I found out what I did wrong, retraction was turned off which caused to extrude on places where it shouldn't ( at the z-line).