Jump to content
Ultimaker Community of 3D Printing Experts
Sign in to follow this  
randyinla

ABS With Color Similar to Faberdashery's Architect's Stone??

Recommended Posts

I have fallen in love with Architect's Stone! I think the neutral grayness goes with a multitude of other shades of white very well. I printed out iRobertl's cable chain parts for the build plate cable using this material and it blends into the inner U2 perfectly.

However, since I've built an acrylic terrarium top for my U2 to print out ABS parts, I found it gets MUCH HOTTER inside than originally anticipated. My PLA-based Architect's Stone cable chain melts a little more every time I print ABS. :oops: The main part that screws into the back of the build plate gets the worst of the heat, pulling it directly off the Z plate. The smaller chain parts also get mushy just from the ambient temp in the enclosed print area.

Does anyone know of any ABS anywhere that has a color close to Architect's Stone? It's a cool, off white... very light gray-ish. I already have a standard 'white' ABS (plain white from iMaker.com) print of the chain, but it looks a tad yellowish compared to the rest of the bright white innards of the U2.

 

Thanks for any suggestions!

-=Randy

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this  

  • Our picks

    • How to 3D print with reinforced engineering materials
      Ultimaker is hosting a webinar where we explain how you can achieve and maintain a high print success rate using these new reinforced engineering materials. Learn from Ultimaker's Product Manager of Materials and top chemical engineer Bart van As how you can take your 3D printing to that next level.
      • 0 replies
    • "Back To The Future" using Generative Design & Investment Casting
      Designing for light-weight parts is becoming more important, and I’m a firm believer in the need to produce lighter weight, less over-engineered parts for the future. This is for sustainability reasons because we need to be using less raw materials and, in things like transportation, it impacts the energy usage of the product during it’s service life.
        • Like
      • 12 replies
×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!