Now add two small ones more for the x direction and you have a complete cover
Honestly... Not tested up to now but I assume that it is silent as ut is some kind of fabric and I put some kind of scotch tape onto the frame to increase slip.
For full cover it is unfortunately too less space but this was my first intention...
Cross fingers, first test tomorrow evening when printing the top cover frame.
TESTED !!!!
works like a charm - absolutely silent and worth.
Unfortunately the print of the 4-section cover went wrong and I had to scrap it, but I will post the files soon... :-)
Here we go - it it mounted and works great. the heat is a bit higher inside the UMO as it acts a bit like a camber clusure...
https://www.youmagine.com/designs/umo-dust-cover
have fun... :-)
Updated/replaced the dust cover components to allow full closure of the top as suggested by https://www.youmagine.com/users/ccw1984.
A rendered picture showing all components can be found at youmagine
https://www.youmagine.com/designs/umo-dust-cover
For this version you´ll need a printhead cover to mount the accordeon cover to the head.
I mounted it a few days ago and it keeps some of the heat inside the UMO. Further it´s silent because of the fabric of the IKEA Schottis.
have fun :smile:
Recommended Posts
tommyph1208 55
very nice, but dosn't it make alot of noise?
Link to post
Share on other sites