Was there a new feature in 14.10 onwards to "hide the seam"?

[jweaver 2]

Did I make this up? Was there a feature after 14.09 which would move the layer change point for each layer so that there wasn't an obvious seem?

I was sure I read this in one of the releases.. But last night I was printing some tubes and there was an obvious seam running straight along the tube...

Did I make this up? Dream it??

Jon

 

[Daid 306]

There was, but it does not help on tubes.

In case of an L shape, it will put the seam in the inside corner instead of somewhere on the outside corners.

 

[jweaver 2]

There was, but it does not help on tubes.

In case of an L shape, it will put the seam in the inside corner instead of somewhere on the outside corners.

 

AHha..Cheers.. i knew I didn't dream it.. Just misunderstood the feature.

thanks..