UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Also, you can check if the endstops are properly working, maybe they are shorted out causing the machine to think the printerhead is at the end all the time and thus refuses to move.
You can also try to swap out the X and Y motor connectors to see if the problem is with the motor or the electronics. If it's in the electronics, try swapping the step motor driver from X and Y (small boards).
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
(Sorry, was out of office when this released)
This update is for...
All UltiMaker S series
New features
Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
Recommended Posts
Daid 306
A few. First, check if the step motor driver is properly configured:
http://wiki.ultimaker.com/Electronics_b ... or_drivers
Also, you can check if the endstops are properly working, maybe they are shorted out causing the machine to think the printerhead is at the end all the time and thus refuses to move.
You can also try to swap out the X and Y motor connectors to see if the problem is with the motor or the electronics. If it's in the electronics, try swapping the step motor driver from X and Y (small boards).
Link to post
Share on other sites