Jump to content

Can you have Z lift with Cura


Recommended Posts

Posted · Can you have Z lift with Cura


I have always used Z lift with other slicers. It stops the extruder dragging on the top of a job which can cause problems with tall objects on small bases. Can this be set up in Cura? I can't see where to implement it.

I only use about 1mm.

  • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
    • Our picks

      • UltiMaker Cura 5.4 stable released
        The full stable release of UltiMaker Cura 5.4 is here and it makes it easier than ever to remove brims and supports from your finished prints. UltiMaker S series users can also look forward to print profiles for our newest UltiMaker PET CF composite material!
          • Like
        • 58 replies
    • Create New...