Ultimaker2 bowden clamps

[gregwar 1]

Hello everyone

Trying to reduce the frictions of the bowden, I'm considering using a 4mm ID / 6mm OD bowden tube

It seems better when trying to move the filament manually inside it

However, the original clamps are too large for it (the stock bowden is like 6.35mm OD)

I've considered using alternative clamps, like Owen's, but it seems only adapted for Ultimaker1 (http://www.thingiverse.com/thing:11864).

I also could add Teflon band to enlarge the tube on the ends... any advice?

Is there good clamps that would adapt to slightly smallest tubes?

 

[pm_dude 27]

You could make your own. Its the best way to get the good fit for your needs

[eldrick 65]

You will need to increase the Retraction length drastically, due to increased slop in the fatter Bowden tube.