UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
· Ultimaker Original Plus - Inverting Feeder
I don't believe that is the correct value to change. It controls whether the step pin is active high or active low. do NOT change that one. It does NOT control the direction.
You can do one of the following:
Switch any 2 of the four wires will (permanently) reverse the direction of the motor thus no need for custom firmware.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
anon4321 16
I don't believe that is the correct value to change. It controls whether the step pin is active high or active low. do NOT change that one. It does NOT control the direction.
You can do one of the following:
Switch any 2 of the four wires will (permanently) reverse the direction of the motor thus no need for custom firmware.
or change:
INVERT_E0_DIR
in configuration.h.and recompile.
Link to post
Share on other sites