UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
The Print Speed setting in the Basic tab is used for any of the four speed values in the Advanced tab when they are set to zero. If a non-zero value is entered in the Advanced tab for Infill, Top/Bottom, Outer Shell or Inner Shell, it takes precedence over the Basic Print Speed.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
xisle 34
The Print Speed setting in the Basic tab is used for any of the four speed values in the Advanced tab when they are set to zero. If a non-zero value is entered in the Advanced tab for Infill, Top/Bottom, Outer Shell or Inner Shell, it takes precedence over the Basic Print Speed.
Try hovering your cursor over one of the values.
Link to post
Share on other sites
personal-drones 44
OK this is all I needed to know. Many thanks for your reply.
Link to post
Share on other sites