Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Restoring Firmware after replacing MCU on Ultimaker 2.1.1 board
Posted
· Restoring Firmware after replacing MCU on Ultimaker 2.1.1 board
Hmmm, I would think it uses the Arduino bootloader for the equivalent Arduino board that has the same MCU since Cura is able to update both the UM2 and UMO. Possibly the bootloader for the Arduino Mega 2560 R3 which is used in the UMO? Is the MCU an ATMEGA?
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
anon4321 16
Hmmm, I would think it uses the Arduino bootloader for the equivalent Arduino board that has the same MCU since Cura is able to update both the UM2 and UMO. Possibly the bootloader for the Arduino Mega 2560 R3 which is used in the UMO? Is the MCU an ATMEGA?
Link to post
Share on other sites