The % is always off in my opinion. I thought it was layer based. And your first layers take longer, are usually biger etc etc.
Just let it finish and see how long it took
The % is always off in my opinion. I thought it was layer based. And your first layers take longer, are usually biger etc etc.
Just let it finish and see how long it took
Advance settings it's important since it can have speed different for outter inner infill. So check it. Unless it's at 0 the 'speed' it's specific for each 'finish'
Thanks Neotko,
I checked the advance settings and reset all values to default and that correct the problem. But what did you mean by "speed it's specific for each finish"
Sorry yeah I mean that the outter layer, inner layer, etc. if you set an outter layer slower your print will look better but inner layer use to affect too, but less. Etc etc. so you can print fast infill and slow outter layer to gain quality and speed and get a better ratio of speed/quality
Recommended Posts
neotko 1,417
Advance settings it's important since it can have speed different for outter inner infill. So check it. Unless it's at 0 the 'speed' it's specific for each 'finish'
Link to post
Share on other sites