complicated design - large files

[simmosam 0]

Hello,

Some time ago i started with the idea of 3D scanning and I took me some time to master the art of it. Now I have managed the technique and get some promising results. Now I want to replicate some of this results and some new drawn stuff. Now my question is: i have some STL files and they are ready for printing but before I buy an ultimaker: can the software handle files of a 150MB? and if someone has done it, the printing process does it still runs smooth?

I remember, from my experience with CNC routers, a big G code file with very high detail was always a problem with smooth running: start stop and jerky movements - because of the small lines and circles.

Have someone expercience with my question?

Greetings

Sam

[Daid 306]

If you print with USB, you will run into buffering problems, causing stutter. But if you print from SD card with an UltiController, you will do fine.

It does take a insane amount of time to slice something that large. You can try slicing with RepG or Cura without having an UltiMaker. If it slices, it should print with the UltiController.

[futurejames 0]

I have sliced and printed bigger than that on the Ulticontroller. I haven't tried anything that big over USB.

[simmosam 0]

Hello,

thank you very much for the feedback.

I have just ordered the Ultimaker and a Ulticontroller

greetings

Sam