Jump to content
Ultimaker Community of 3D Printing Experts
  • Sign Up
chazah

X Axis Belts too tight ?

Recommended Posts

Posted (edited) · X Axis Belts too tight ?

So my Ultimaker v1  has been sitting in the basement for the last few months and now the X axis is really stiff ..

I tried to print something small and the print failed due to slipping

I have oiled the rods but yet no avail

: S

Edited by Guest

Share this post


Link to post
Share on other sites
Posted · X Axis Belts too tight ?

You can always replace the belts if they are bad, but I don't think slipping would be caused by the belts being too tight. Especially after sitting for a few months.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...