Yes it's about somebody else's UM original, one I am about to work with soon. At home I have an UM2 myself.
It Also fails otherwise when not heating up, the first time it failed was when I was heating up. But later it also failed on other occasions
I don't think that matters or makes any difference, display just fades after a few sec. Most of the time right after I power the UMO, with the netadapter or through the USB, with or without touching the knob.
That is something I will have to try out ....
That is what I understood as wel, but when I connected it to my MacBook, Cura suggested an update after I wanted to select the right printer the UMO instead of my own UM2. And I think (seeing the picture) I did install the correct update for an UMO. It says so in the config.box on the pic..
Thx for the tips I'm going to try out some more stuff now, have a closer look at the firmware version I updated and disconnect the kit and try. And look some more at when it starts to fail so I can be more specific. I'll keep this post updated as soon as possible.