I'm not sure when exactly this problem first occured, but I think it might have come with Cura 4.9.
My printer is printing perfectly, until it suddenly stops in the middle of a layer. After slicing the file multiple times and also changing the 3D-Model a little, it still always is the same layer it stops in. Neither does the display freeze, nor does the Printer cool down, it just stops in the middle of the inner wall. I already took a look at the G-Code, but can't find anything (not that I am a Pro in inspecting G-Codes...).
I am using an SD-Card, and also had the problem with a printed temperature tower which also stopped only a few layers before the end, alike here. The Temperature tower I was able to print without problems a couple times already, so the model itself is fine.
My next step now will be to downgrade to Cura 4.8 again, but in the meantime I would be very thankful if you got any advice or other solutions for me.
The G-Code is appended, here the Print stops at Z=13.80 in the inner wall.
When I try to stop the Print via the Display, it says stopping... but does not do anything, I suppose because the Printer waits to finish the current G-Code it is executing. So my thought was, that there might be a Code snippet which takes forever and therefor breaks the Print.
AI3M_Extruder_Knob.gcode