artisticmusician

I am printing my design in TPU and I would like for it to be a little more bendy. I found that a raft is the perfect ammount. So I made the model and booleaned out what the raft would leave out. the model was so complex it wouldn't export. So is there a way for me to tell cura to print the entire model as if it were a raft? Ideally I'd like to have a couple areas print normally and everything esle print as raft. But if that's not possible then then it's ok that the entire model prints as a raft.,

Thank you. Very much!

Thanks I have added the Cura file to the post. CE3PRO_ElephantHead.3mf

So when I run the slicer it seems that cura is shrinking the model. The fact is I know it's shrinking the model because I printed without checking the preview and the print was very small. Is there a setting I accidentally edited that is causing this? I appreciate any help. Thanks.

Hello, I'm trying to get the proper settings to use Cura slicer to print on an Ender 3 S1. It is not one of the listed 3D printers. Is there some place I can download these? Thanks in advance.