DidierKlein 729
The print speed parameter is taken into account if you specify 0 for infill, top/bottom, outer and inner shell.
If you specify a specific value there it will override the print speed parameter.
Bottom layer speed is the speed of the first layer, it should always stay low for good adhesion.
Top and bottom represents the speed for the top and bottom layers (depending on the top and bottom height (or number of layers for top/bottom if you prefer)).
By the way your travel speed can be increased to 150 (default) or more up to 250mm/s, this is the speed of non printing moves
Recommended Posts
lairdb 3
(These are, incidentally, my current PLA settings for most uses, plus a TweakAtZ to double speeds at layer 4.)
Link to post
Share on other sites