Print settings for Prusa i3 (rework)?

[Russbo 0]

Hi there.

I've been using Slic3r but haven't really been satisfied with my results - support material is pretty awful under Slic3r and I've heard that it's better under Cura. Does anyone else have the same or similar printer that could point me in the right direction/C+P their settings?

I use 1.75mm PLA.

Thanks

[gr5 2,189]

c+p = copy paste?

I'm sure people do it but you might not get a reply here as a lot of people left the forum a few months ago so most remaining are Ultimaker2 people. Try a Prusa or reprap forum?

[Russbo 0]

Yes it does haha. Oh that's a shame, I guess I'll try there, thanks