Typiquement, là, je découpe en morceaux plus faciles à imprimer.
-
Our picks
-
Ultimaker showcase | April 2022 | 4pm CEST | 10am EDT
SandervG posted a topic in Official news,
I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot!-
-
- 4 replies
Picked By
SandervG, -
-
New here? Get ahead with a free onboarding course
SandervG posted a topic in Official news,
Hi,
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.-
-
- 12 replies
Picked By
SandervG, -
-
Recommended Posts
DidierKlein 729
Ca va être compliqué sans supports à mon avis.
Ca fait quelle taille?
Niveau paramètre je mettrais des couches de 0.1mm vitesse lente (30mm/s max) température au minimum
Link to post
Share on other sites