Screwed up my firmware! Can I reset my firmware?

[Phalconheart 2]

I just did a big NoNo I think. I wanted to install the new Cura but without realizing it, Ultimaker's site brought me to an OLDER version of Cura (12.something). Went through the installation and it said to upgrade the firmware. So I plugged in the USB cable and updated the firmware as per the instructions. Turns out it installed and older version of the firmware and #$%@#$ up my Ultimaker 2!!!!

Now i don't have the display on my UM2 anymore and now that I've actually installed the proper Cura udate, when I try to update the firmware, the progress bar doesn't move at all... NOTHING... NADA!!!!

I have a pending order that has to go out... this is NOT good timing.

Is there a way to flash the firmware to get my UM2 up and running again???

Please help!

Phalconheart

[xisle 34]

Have you tried 15.04? You should be able to update firmware from that stable version.

[Phalconheart 2]

Thanks, I was able to reload the original firmware from the previous version of Cura.

All is well for the moment.