Save it in the configuration.h and recompile it.
Right, I was interested in fine tuning without recompiling.
Save it in the configuration.h and recompile it.
Right, I was interested in fine tuning without recompiling.
Save it in the configuration.h and recompile it.
Right, I was interested in fine tuning without recompiling.
So you adjust the parameters with M304 and when you found the 'right' ones, you write them into the source code and recompile it once. You anyway had to recompile the source code in order to activate pid for the bed, correct?
btw: what makes you think the autotune feature gives bad values?
So you adjust the parameters with M304 and when you found the 'right' ones, you write them into the source code and recompile it once. You anyway had to recompile the source code in order to activate pid for the bed, correct?
You could say the same for extruder PID settings, but they are listed in the controller menu, and respond to being saved to EEPROM. Seems like there must be a correctable difference in the firmware between extruder and bed settings. That is what I am asking about, not how to do something I have obviously already done.
You could say the same for extruder PID settings, but they are listed in the controller menu, and respond to being saved to EEPROM. Seems like there must be a correctable difference in the firmware between extruder and bed settings. That is what I am asking about, not how to do something I have obviously already done.
Now I see your point. You compare the situation of the nozzle PID settings with the bed PID setting. Sorry for not seeing it earlier, it's 30°C+ since a few days here...
Recommended Posts
Dim3nsioneer 558
Save it in the configuration.h and recompile it.
Link to post
Share on other sites