Printing fast and slower for perimeters ?

[ian 32]

Is there some way, that i can print my models at full speed 400 and make my ultimaker print the oustide perimeters slower at 100 or 150 ?

sort of like

infill speed

perimeter speed

is that possible ?

[Daid 306]

Not with settings, but the Cura printing interface of 12.08 allows this, as you can set different speed modifiers for the infill and walls.

[ian 32]

where exactly are these settings ?

i can see print speed.

print temp

travel speed

max z speed

bottom layer speed

???

[Daid 306]

You can see them during USB printing, if you dont' use PrintRun, but Cura to print.

[ian 32]

so when i print from stand alone sd card using ulticontroller... then these optios are not available ?

[Daid 306]

Nope.

[ian 32]

mmmmmm nicht gut.....

i have now moved my home printer to a seperate room from my computers.. about 10 meters from my pc station.

i dont think a 10m usb cable would work.

i really hope this option comesinto the gcoding of the next cura.

that would be really helpful.

Ian

[snowygrouch 1]

I would also like to request that such features be available in GCODE generation for SDCARD printing...

There is no way I am leaving on my PC for 30hours just to send GCODE, so as Ian says, that

would be really helpful.

Regards

Calum

[msurunner 2]

+1 on the SDCARD printing