Those dots that you talk about are they the yellow ones in the picture above?
These are infill layers, in cura 15.04 the infill is put down before the outer layers.
increase your bottom layer thickness to 0.3 as this will help solve all those travels on the first layer.
Yes that's right, the yellow ones around the outer edge. I'm finding simplify3d is just simply printing two shells without doing any of those moves. If the model was thicker, this wouldn't bother me, but it's leaving blemishes around the outer edge since the model is so thin and these moves continue all the way to the top .
I've tried increasing the bottom layer, same problem, changed to infil/outer perimeter order, same problem. The only way I could fix the problem was to change the shell thickness to 0.9 as can be seen here. I understand this isn't ideal but is there any problem doing this ?
Recommended Posts
Labern 775
Those dots that you talk about are they the yellow ones in the picture above?
These are infill layers, in cura 15.04 the infill is put down before the outer layers.
increase your bottom layer thickness to 0.3 as this will help solve all those travels on the first layer.
Link to post
Share on other sites