There's a 5V fan plug on the board that is what um2 uses to cold the hot area. I use that. There's also another fan plug that was intended to cold the board.
The only way to plug a 12v it's with two in series (not recommend).
https://github.com/Ultimaker/Ultimaker2/blob/master/1091_Main_board_v2.1.1_(x1)/Main%20Board%20V2.1.1.pdf
Thanks for the help.
Can you show me where to connect it to the board and what to so with the firmware? I have no experience so far with firmware and such.
I would very much appreciate it!
Recommended Posts
neotko 1,417
There's a 5V fan plug on the board that is what um2 uses to cold the hot area. I use that. There's also another fan plug that was intended to cold the board.
The only way to plug a 12v it's with two in series (not recommend).
https://github.com/Ultimaker/Ultimaker2/blob/master/1091_Main_board_v2.1.1_(x1)/Main%20Board%20V2.1.1.pdf
Link to post
Share on other sites