Jump to content

A short question about the circuit diagram of Ultimaker 2

swq0603

By swq0603
in UltiMaker 3D printers

 Share

Recommended Posts

swq0603

swq0603 1

Posted
Posted · A short question about the circuit diagram of Ultimaker 2

I find that there is a solder jumper in the circuit diagram of Ultimaker 2. I just do not understand what is the solder jumper. Why there is a solder jumper added to the nReset. Thanks in advance!

5a33151f4937a_circuitdiagram.JPG.f4743ceac3609bfdd4482dc8b24e2af3.JPG

5a33151f4937a_circuitdiagram.JPG.f4743ceac3609bfdd4482dc8b24e2af3.JPG

    • Link to post
    Share on other sites
    SandervG

    SandervG 1,521

    Posted
    Posted (edited) · A short question about the circuit diagram of Ultimaker 2

    Hi!

    I went out and asked my technical colleague who asked our friends from R-D (it wasn't something I knew the answer to) and what I understand is that this jumper allows your Arduino to stay open when you plug in the USB and you can install new firmware.

    Without it, the Arduino wouldn't reset and you wouldn't be able to upload new firmware.

    Hopefully that is the answer you were looking for.

    Have a good day!

    Edited by Guest
    • Link to post
    Share on other sites

    Create an account or sign in to comment

    You need to be a member in order to leave a comment

    Create an account

    Sign up for a new account in our community. It's easy!

    Register a new account

    Sign in

    Already have an account? Sign in here.

    Sign In Now
     Share
    Go to topic listing

    • Our picks

      • UltiMaker Cura 5.7 stable released

        UltiMaker Cura 5.7 stable released

        ArunC posted a topic in UltiMaker Cura,

        Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more. 
         
          • Like
        • 16 replies
        MariMakes

        Picked By

        MariMakes,

      • Release Notes: S-Line Firmware 8.3.0 (Latest)

        Dustin posted a topic in Firmware,

        S-Line Firmware 8.3.0 was released Nov. 20th on the "Latest" firmware branch.
        (Sorry, was out of office when this released)

        This update is for...
        All UltiMaker S series  
        New features
         
        Temperature status. During print preparation, the temperatures of the print cores and build plate will be shown on the display. This gives a better indication of the progress and remaining wait time. Save log files in paused state. It is now possible to save the printer's log files to USB if the currently active print job is paused. Previously, the Dump logs to USB option was only enabled if the printer was in idle state. Confirm print removal via Digital Factory. If the printer is connected to the Digital Factory, it is now possible to confirm the removal of a previous print job via the Digital Factory interface. This is useful in situations where the build plate is clear, but the operator forgot to select Confirm removal on the printer’s display. Visit this page for more information about this feature.
          • Like
        • 0 replies
        MariMakes

        Picked By

        MariMakes,
      View All
    ×
    ×
    • Create New...