Jump to content
Ultimaker Community of 3D Printing Experts

How to design laterally increasing infills


nikhilbala

Recommended Posts

Posted · How to design laterally increasing infills

Hi,

Is it possible to print a model wherein different fill ratios in the same layer. I need to print a laterally increasing fill ratio for my model (say from 50% infill to 80% infill) in the same layer. Is there any software for designing such a model?

Thanks in advance

  • Link to post
    Share on other sites

    Archived

    This topic is now archived and is closed to further replies.

    ×
    ×
    • Create New...