Jump to content
hearbob

What might be causing these marks?

Recommended Posts

Posted · What might be causing these marks?

Hi, i assume this is a hardware or a maintenanceIMG_4610.thumb.JPG.cda0d8ecb9dc055891ea1a6661fdd120.JPG issue but I am not sure as to what or why. any help would be appreciated.

IMG_4610.thumb.JPG.cda0d8ecb9dc055891ea1a6661fdd120.JPG

Share this post


Link to post
Share on other sites
Posted · What might be causing these marks?

It's probably infill showing through. Try increasing the wall thickness and make sure that perimeters are printed before infill. The setting for that is in Expert->Open expert settings->Infill prints after perimeter.

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×
×
  • Create New...

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!