Probably the nozzle it's dragging filament from the first layers, then it builds more and drops burned on the print. Check the first layers and adjust the bed alignment so it don't drags filament.
Also the temperature could be too high.
As temperature I use 215 degrees of Celsius. The first layers look nice, but after a while (5mm or so) the bubbles appear. I will test soon!
Recommended Posts
neotko 1,417
Probably the nozzle it's dragging filament from the first layers, then it builds more and drops burned on the print. Check the first layers and adjust the bed alignment so it don't drags filament.
Also the temperature could be too high.
Edited by GuestLink to post
Share on other sites