not sure if NF was ever able to connect to the UM, afaik, it was always a pipe dream. save your gcode to your disk or SD, and print via printrun or SD card.
not sure if NF was ever able to connect to the UM, afaik, it was always a pipe dream. save your gcode to your disk or SD, and print via printrun or SD card.
That is great advice Joergen. Connecting Netfabb to Ultimaker usually leads to your Ultimaker acting like it needs an Exorcism.
IMHO based only on my experiences. The management may not agree with the authors thoughts and opinions.
Recommended Posts
jesus 0
Hey man, Im having the exact same problem, and no one tells how to turn back to the default firmware once you update it on cura... "if that would be the cause" got excited to read your post but no one gave you any feedback...
how did you solve it???
Link to post
Share on other sites