UM2 Speeds - S3D settings vs. Cura?

[EastUm2 0]

I hope someone can clear up this speed question.

 I am a high school teacher and bought a UM2 last spring. When I came back to school-last fall-I found a Makergear2 w/Simplify3D waiting for me.  Lucky me now I have 2 different printers!  However, I am now switching between Cura and S3D. The speeds are referenced as mm^3 in Cura and mm/min in S3D. I am sure there is a way to convert these speeds to develop some consistency/understanding but I have not found it here yet. Just wondering if the UM2 community might be able to clear this up.

[DidierKlein 729]

In Cura speeds are in mm/s in S3D it's mm/min so you just have to divide or multiply by 60

[neotko 1,417]

Or change it on the Preferences of S3D