Bed Leveling only first point

[Kiessar 0]

Hi,

I installed the newest version of cura and the default firmware.

I am not able to adjust the height on the second and third point only on the first.

Therefore the bed is not moving when I am turning the wheel.

Because the bed and head is moving in other situations and the first point is working fine, i think that it is a software issue.

Any Ideas what  the cause could be?

Best Regards

Edited February 25, 2016 by Guest

[IRobertI 503]

That's expected behaviour. You use the knob on the front for the back position only. For the front positions you turn the thumb screws under the platform.