Jump to content
Ultimaker Community of 3D Printing Experts

My Ultimaker and Form1+ had a baby :0)

Recommended Posts

I saw a review of this one by maker's muse, it looks like a fun printer to play with :)so cute ^^


Yes, it's quite small and cute.

The print quality is surprising very good for 200ish euro worth of 3D printer :)

I've printed at 0.3, 0.2 and 0.1mm @ 15-20mm/sec and I've very impressed with the results.

I will say this, it needs a few mods to get the most out of it. But nothing expensive or hard to print(SD and LCD, fans etc).

Share this post

Link to post
Share on other sites

I have a co-worker wanting to spend a little money and try 3D printing and asked about this model.  If you don't mind sharing your experience with him here, he'd appreciate it.


Lots of info and experiences here from the 1.0 version up to 1.5


Lot of info for the mods as well.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now


Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!