It this with Ultimaker-white-PLA? You need to up the temperature with 10-15C for that PLA, or else it won't flow correctly. Not sure what's causing it.
It this with Ultimaker-white-PLA? You need to up the temperature with 10-15C for that PLA, or else it won't flow correctly. Not sure what's causing it.
I used the Faberdashery stone white colour printing at 206C. Also the print speed is at the default Cura setting of 50mm/s.
Recommended Posts
ian 32
what temprature are you printing ? could be a little too low ?
what speed are you printing ?
also maybe loosen the spring mechanism at the back of your new extruder upgradem maybe its pushing too tight against the wheel and filament and stopping the free flow of plastic ?
best wishes.
Ian
Link to post
Share on other sites