UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
That sounds like 'underextrusion'. Basically you might need to use higher temp.
Anyhow knowing what causes it, and there's a gazillion different thinks that can cause this, from the settings to the machine itself. You need give much more details.
- Temp
- Full range of settings
- Machine and model used
- Lifetime of the machine?. Did it print like this before?, it's this the first print?, it's a complex model?
More data much more data. And specially a photo of the print.
In the Cura 5.8 stable release, everyone can now tune their Z seams to look better than ever. Method series users get access to new material profiles, and the base Method model now has a printer profile, meaning the whole Method series is now supported in Cura!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Recommended Posts
neotko 1,417
That sounds like 'underextrusion'. Basically you might need to use higher temp.
Anyhow knowing what causes it, and there's a gazillion different thinks that can cause this, from the settings to the machine itself. You need give much more details.
- Temp
- Full range of settings
- Machine and model used
- Lifetime of the machine?. Did it print like this before?, it's this the first print?, it's a complex model?
More data much more data. And specially a photo of the print.
Link to post
Share on other sites