Jump to content
Ultimaker Community of 3D Printing Experts
joelmongeon

Bondtech QR Ultimaker 2 + firmware?

Recommended Posts

I've upgraded my UM2 to a UM2+ with the upgrade kit but I kept my Bondtech extruder instead of using the new feeder. I went ahead and updated the firmware to UM2+ like the instructions said and then realised that on my UM2 I had installed a custom firmware form Bondtech.

Is there a firmware from Bondtech for the UM2+? Or just use the UM2 firmware that is on their site?

I'm itching to start printing but don't want to start until I get that sorted out.

Thanks in advance!

Joel

Share this post


Link to post
Share on other sites

Ok, I just did a quick test with the UM2+ firmware by running through the material change option.

My Bondtech feeder is now going is reverse. Would changing the E-steps to a negative number be an easy way to reverse the feeder direction? So instead of setting my E-Steps to M92 E492.45

I could save it as

M92 E-492.45?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

×

Important Information

Welcome to the Ultimaker Community of 3D printing experts. Visit the following links to read more about our Terms of Use or our Privacy Policy. Thank you!