UltiMaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Using 15.04.3 version of cura- how do i start a print?
Posted
· Using 15.04.3 version of cura- how do i start a print?
Get pronterface/printrun and install it. Connect your computer to the printer through USB. This software allows you to be very careful - for example you can move X axis by 1mm and makes sure nothing bad happens without having to home it. You can then move it 10mm and see if steps/mm is correct and also edit these settings and save them from pronterface. You can also test your limit switches and then test homeing procedure. All one axis at a time. Then test temperature and heater.
I forget where you get it as I am travelling this week but if you google pronterface and gr5 at site:ultimaker.com you should be able to find it.
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
We are happy to announce the next evolution in the UltiMaker 3D printer lineup: the UltiMaker Factor 4 industrial-grade 3D printer, designed to take manufacturing to new levels of efficiency and reliability. Factor 4 is an end-to-end 3D printing solution for light industrial applications
Cura 5.7 is here and it brings a handy new workflow improvement when using Thingiverse and Cura together, as well as additional capabilities for Method series printers, and a powerful way of sharing print settings using new printer-agnostic project files! Read on to find out about all of these improvements and more.
Recommended Posts
gr5 2,192
Get pronterface/printrun and install it. Connect your computer to the printer through USB. This software allows you to be very careful - for example you can move X axis by 1mm and makes sure nothing bad happens without having to home it. You can then move it 10mm and see if steps/mm is correct and also edit these settings and save them from pronterface. You can also test your limit switches and then test homeing procedure. All one axis at a time. Then test temperature and heater.
I forget where you get it as I am travelling this week but if you google pronterface and gr5 at site:ultimaker.com you should be able to find it.
Link to post
Share on other sites