CURA 2.1.3 - Incorrect Machine Height

[neuronex 2]

Hi,

Since downloading CURA 2.1.3 it displays the incorrect height (the blue wireframe box) for the Ultimaker 2+. I don't have the UM2+ attached via USB so this is a software issue. The only workaround is to add a new UM2+ machine each time I start CURA which then gives me the correct height, but it defaults to the incorrect height the next time I use CURA.

This happens regardless of the part I'm printing.

Anyone else having the same issue?

Windows 7.

CURA defaults to incorrect height:

If I add a new machine & select UM2+ it temporarily shows the correct height:

Edited August 25, 2016 by Guest

[meduza 191]

If you have selected "print one at a time", Cura will show the low box to tell you what you can print "one at a time" (i.e this is what fits under the gantry height)

[neuronex 2]

If you have selected "print one at a time", Cura will show the low box to tell you what you can print "one at a time" (i.e this is what fits under the gantry height)

 

Ah - that's it.

Thanks.