Ultimaker uses functional, analytical and tracking cookies. Tracking cookies enhance your experience on our website and may also collect your personal data outside of Ultimaker websites. If you agree with the use of tracking cookies, click “I agree, continue browsing”. You can withdraw your consent at any time. If you do not consent with the use of tracking cookies, click “Refuse”. You can find more information about cookies on our Privacy and Cookie Policy page.
Posted
(edited)
· Bed Leveling with Cura 2.1 and UMO+
That is not a stupid question at all :-)
There is actually only one way to do it in Cura 2.1, and it is not very obvious, since it requires you to add the machine again and do the bed leveling trough the setup wizard.
This is a known issue and will be fixed in Cura 2.2 where this button will be found in the "manage printers" window:
Thanks meduza! I figured I could do it that way, but it seemed awkward. Until Cura 2.2 is released, I will continue to use 15.04.06 for the bed leveling function.
1
Link to post
Share on other sites
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
I'm excited because I've personally produced this showcase event, so if you are curious what else I'm up to nowadays, come check it out and say hi in the chat! It would mean a lot!
Often getting started is the most difficult part of any process. A good start sets you up for success and saves you time and energy that could be spent elsewhere. That is why we have a onboarding course ready for
Ultimaker S5 Pro Bundle, Ultimaker S5, Ultimaker S3 Ultimaker 2+ Connect.
They're ready for you on the Ultimaker Academy platform. All you need to do to gain access is to register your product to gain free access.
Ready? Register your product here in just 60 seconds.
Recommended Posts
meduza 190
That is not a stupid question at all :-)
There is actually only one way to do it in Cura 2.1, and it is not very obvious, since it requires you to add the machine again and do the bed leveling trough the setup wizard.
This is a known issue and will be fixed in Cura 2.2 where this button will be found in the "manage printers" window:

Edited by GuestLink to post
Share on other sites
rowiac 53
Thanks meduza! I figured I could do it that way, but it seemed awkward. Until Cura 2.2 is released, I will continue to use 15.04.06 for the bed leveling function.
Link to post
Share on other sites